Makita VC008G Manuel D'instruction page 16

1. Shoulder the vacuum cleaner body and fas-
ten lower and upper belts. Adjust the tightness as
necessary.
Fig.33
2.
Press button to start vacuuming. If you want
to change the suction power, press
desired suction power is selected. Press
Fig.34
During the operation, hook the switch box on the D-ring
or the loop on the lower belt. The hook can be slanted
for lighting forward when hooked on the loop.
1
Fig.35
► 1. D-ring 2. Loop
NOTE: The vacuum cleaner and the LED light will
automatically switches off when the appliance / bat-
tery protection system works due to the overheat of
the appliance / battery, or the reduced air-flow into the
machine caused by clogged hose, pipe, filter or other
reasons. In this case, remove the cause of the prob-
lem before restarting. For more information, refer to
the section "Appliance / battery protection system".
button until the
button to stop.
2
16 ENGLISH
3. Replace the filter bag when it becomes full. Open
the lid and take out the filter bag. Pull the strip on the
side of the opening to shut the filter bag and dispose of
the filter bag in whole.
1
Fig.36
► 1. Strip
When using a dust bag, take out the dust bag and dis-
pose of the dust by releasing the latch.
1
Fig.37
► 1. Latch
NOTICE:
Periodically check the filter bag if it is
full. Continuous use with the filter bag full results in
reduced suction power.
NOTICE:
Do not use an used filter bag. The filter
bag is designed for single use. Using filter bag repeat-
edly may cause clogging of the filter and results in
damage to the cleaner. If you want to use the bag
repeatedly, use a dust bag.