camry Premium CR 4498 Mode D'emploi page 4

should be consulted in this regard.
15. NOTE: The milk frother has a heating function. Be very careful while opening the lid
and pouring milk in so as to avoid getting burnt.
16. To avoid being splashed with milk or foam (which may be hot), always put the lid on the
milk frother before you switch it on.
17. Hold the milk frother by the handle (1e). The pot housing becomes hot during
operation.
1. DEVICE DESCRIPTION
a. Lid
d. Maximum filling level mark
g. Control button
2. Filling level indicators
a. MAX level for heating milk:350ml (2a)
b. MAX level for cold / hot milk frothing:250ml (2b)
INSTRUCTIONS FOR USE
1.Choose the whisk for the desirable effect. Whisk for milk frothing (1b). If you want your milk frothed. Whisk for heating the milk (1c). If
you want your milk heated.
2. Pour in a portion of milk (preferably 3.2% fat). The milk should cover the whisk (1b or 1c), and reach marked minimum level but not
exceed the maximum level mark (1d). Maximum level for milk heating is 350ml (2a) and for milk frothing is 250ml (2b).
NOTE: For best results use cold, fresh milk. Non-dairy milk doesn't froth as well as dairy milk. For best effect use "barista" type plant
based milk.
NOTE: Do not exceed the MAX line inside the jug.
3. Put the lid (1a) on the jug and place the jug on the power base (1h). Insert the power plug into an electrical outlet. The mode icons will
light up for one second.
4. Touch control button (1g) and choose desired program: cappuccino, latte, hot chocolate, cold.
- once - if you want to heat and froth your milk (with whisk 1b) to get the cappucino froth
- twice - if you want to heat and froth your milk (with whisk 1b) to get the latte froth
- three times - if you want to heat and froth your milk (with whisk 1b) to prepare hot chocolate. Or if you want only to heat your milk (with
whisk 1c).
- four times - if you want your milk to keep cold and just froth it (with whisk 1b) for iced coffee or flavoured milk.
The light above the function will flash 2 seconds and milk frother will start working automatically.
5. The appliance will run until a high temperature of milk is reached. Once its done it will stop automatically and beep three times.
NOTE: AFTER OPERATING BOTTOM OF THE JUG IS HOT. DO NOT TOUCH IT!
NOTE: DO NOT TOUCH THE HEATING PLATE (1i).
6. To turn off the appliance before the end of the cycle, press the control button (1g) during work.
NOTE: DO NOT take off the jug from the heating plate when its operating.
NOTE: Milk heats to approximately 68-78°C. This temperature ensures the best flavor of the coffee.
CLEANING AND MAINTENANCE
1.Before washing the appliance, make sure it cooled down and is disconnected from the power socket.
2.Always remove the jug from the power base before cleaning.
3.Clean jug with a soft cloth and washing-up liquid.
4.The device should be washed after each use.
IMPORTANT: Do not put milk frother base into water.
NOTE: The milk jug is dishwasher safe but should not be washed in higher temperatures than 70°C/ 158°F.
5.You can also clean the frother by pouring water into it and running for one cycle (this prevents the whisk from blocking by milk
sediments accumulating on the agitator shaft seal).
TECHNICAL DATA:
Power supply: 220-240V ~50/60Hz
Power: 500W
Maximum power: 1000W
Capacity: frothed: 250ml / heated: 350ml
b. Whisk for milk frothing
e. Handle
h. Power base
4
c. Whisk for heating milk
f. Milk jug
i. Heating plate