Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
Vacuuming brush head
-
Wall bracket
-
Jalisco brush
-
2-in-1 accessory for furniture
-
Accessory for corners
-
-
Flexible tube
-
Accessory for pets
-
Instruction manual
3. PRODUCT ASSEMBLY
Battery assembly
Fig. 2
-
Insert the battery in the corresponding slot on the main body. Once inserted, it will click
into place. Make sure it's secured in position.
-
To remove the battery, press the release button and remove the it.
Attaching the suction tube to the main body
Fig. 3
-
To install the suction tube on the main body, align the two parts so that they match, and
insert the tube into the main body until it snaps into place.
-
To disassemble, press the release button and pull the suction tube while holding the main
body firmly.
Accessories assembly
Fig. 4
To complete the installation of the Upright Vacuum Cleaner, once the suction tube is connected
to the main body, hold the tube in an upright position and insert the desired accessory into it.
Installing the wall bracket
Fig. 5-6
Attach the adapter to the wall bracket as shown in Figure 5.
-
Place the wall bracket on the wall and mark the points where the holes for fixing the
-
bracket are to be drilled. It is important that the suction base rests on the floor so that the
wall bracket does not support the full weight of the hoover.
Drill the holes and fix the wall bracket with the expansion screws, then place the vacuum
-
cleaner and the attached accessory on the wall bracket as shown in Figure 6.
48
Publicité
