Goldstar M1804R Manuel D'utilisation page 14

Data(For 115V model only)
Line Cord Plug Use Wall Receptacle Power Supply
,I _.._ l Do not under any "_
_: _-_:,._/circumstances _t
_}--j,,/_ or remove the
.......... _CS)-z/ grounding prong
_..from the p_ug, .,_
Power supply cord with
i 3-prong grounding plug
Standard 125V, 3-wire grounding
receptacle rated 15A, 125V AC
Use 15 AMP. time
delay fuse or 15 AMP.
circuit breaker.
USE OF EXTENSION CORDS
Because of potential safety h_ar_, we strongly discourage the use of an extension cord. However, if you wish to
use an extension cord, use a CSA cerlJfied/UL-listed 3owire (grounding) extension cord, rated i5A, 125V.
Data(For 230/208V model only)
Power Supply Line Cord Plug Use Wall Receptacle
Do not under any"
r-" "---_--.._. oiroumston_s o_t
t
I _ _ I or remove the !
_.-[_r_ grounding prong
Lr__rj j[om !heP!_!:
J
I I
supply cord with Standard 250V, 3-wire grounding
3-prong grounding plug receptacle rated 15A, 250V AC
Use 15 AMP, time
delay fuse or 15 AMP.
circuit breaker.
t _ ("Do not under any "_
........ C_/circumstances cut
_-- _-j,t or remove the
Use
20 AMP. time
-,z_ grounding prong
from tt_e plug _
delay fuse or 20 AMP.
circuit breaker.
:_ Power supply cord with Standard 250V, 3-wire grounding
i 3-prong grounding plug receptacle rated 20A, 250V AC
All wiring should be made in accordance with local electrical codes and regulations.
NOTE • Aluminum house wiring may pose special problems. Consult a qualified electrician.
[] ELECTRICAL SAFETY
IMPORTANT GROUNDING INSTRUCTIONS
Air conditioner has a three-prong grounding plug
on its power supply cord, which must be plugged
into properly grounded three-prong wall
receptacle for your protection against: possible
shock hazard
230, 208, and 230/208 VOLT UNITS'
Thesie units are equipped with a three-prong
grounding plug on the power supply _rd, which
must be plugged into a matching properly
grounded three-prong wall receptacle for your
protection against possible shock h_ard. If such
an outlet is not present, one must be installed by
a qualified electrician in accordance with the
National Electrical Code and local codes and
ordinances
NOTE: DO NOT USE AN EXTENSION CORD
ON 230, 208, AND 230/208 VOLT UNITS,