Goldstar M1804R Manuel D'utilisation page 12

Cabinet Installadon
1, Open the window Mark a line on the center
of the window stool between the side
window stop moldings,
Loosely attach the sill bracket to the support
bracket using the carriage bolt and the lock
nut.
Sill
Bracket
Carriage
Bo_t
(M-Screw)
nut
2. A_ach the sill bracket to the window s,ill
using the screws (Type B),
Carefully place the @binet on the window
stool and align the _nter mark on the
bottom front with the center line marked
window stool,
Carnage
and Jocknut
Machine s crew(Ty_D)
andlocknut
O_er edge
window
sill
B)
"Sill bracket
3. Using the Moscrew and the lock nut, attach
the support bracket to the cabinet tra_ hole.
Use the first track hole aRer the silt bracket
on the outer edge of the window sill. Tiglhten
the carriage bolt and the lock nut Be sure
the cabinet slants ou_ard,
CAUTION: DO NOT DRILL A HOLE IN THE
BOTTOM PAN,
The unit is designed to operate,
with approximately 1/2" of water
in bottom pan.
4, Pull the bottom window sash down behind
the Top retainer bar until they meet,
retainer
bar
Window stool
Frontangle
Window sash retainer bar
Frame cu_ain
Foam-PE
NOTE: 1. Do not pull the win_w sash down so
tightly that the movement of Frame
curtain is restricted. Attach the
cabinet to the window stool by
driving the screws (Type B) through
the cabinet into window stool.
2. The _binet should be installed with
a very slight tilt downward toward the
outside.
Front Angle
Screw(Ty_ B)
track