Digital Audio Setup; Dolby Digital Setup (Dual Mono); 3D Processing; Night Mode (Dynamic Range Control) - Teac DR-H300 Manuel Du Propriétaire

Digital Audio Setup

SPDIF OFF:
Select this when you don't use the DIGITAL OUT or the HDMI
terminal.
No signal is output from these terminals.
ALL:
Select this when the unit is connected to an audio component
equipped with a built-in Dolby Digital or DTS decoder via the
DIGITAL OUT or the HDMI terminal.
PCM only (Default):
Select this when the unit is connected to an audio component
such as amplifier/receiver, CD recorder or MD deck via the
DIGITAL OUT or the HDMI terminal.

DOLBY DIGITAL Setup (Dual Mono)

STEREO
Left channel is output from the left speaker, and right
channel is output from the right speaker.
L-MONO
Left channel is output from the front left and right speakers.
R-MONO
Right channel is output from the front left and right speakers.
34
Settings (Audio Setup Page)

3D Processing

This setting provides following sound effects:
Off, Concert, Living Room, Hall, Bathroom, Cave, Arena,
Church

Night Mode (Dynamic range control)

ON
Applies dynamic range control to Dolby Digital material,
reducing the volume of loud sounds, and increasing the
volume of quiet ones. This is useful for spoken word material,
etc. as well as nighttime listening.
OFF (default)
Turns off the audio dynamic compression.
< This function is effective only when playing back a DVD disc
recorded with Dolby Digital. This control has no effect on
other discs.
< The overall effect of this setting depends on many things: the
disc being played, the amplifier, and the speakers used for
reproduction.