Helo RA 18 Manuel Produit page 26

User and installation manual RA 18
1
3 Subsequently, fasten the control panel onto the
All manuals and user guides at all-guides.com
RA 18 Control panel installation
First fasten the wooden base plate for control
panel to the wall with the provided screws. Make
sure the base plate is placed within the allowable
installation area (for detailed instructions please
refer to the sauna heater manual). Use a builder's
level to make sure the plate stays straight during
installing.
2 Place the control panel accurately on the
wooden base plate and drill a 2 – 3 mm hole
through the upper part of the casing. Depth of
the hole is not critical, because the purpose of
the hole is to merely assist driving the screw
into the wooden base.
wooden base plate with screws. Make sure the
control panel is straight in relation to the base
plate, drill a hole through the lower part of the
casing and fasten with screws.
4 Before driving the screws tightly, make sure
the cable is not pressed between the control
panel and the wooden base, but securely
placed in the intended groove.
5 Set the control panel frame in place by
pressing with your hands.
6 The frame is removed by pressing the four
grooves in the frame with a small rod or
screw driver and slightly twisting outwards.
7