Helo RA 18 Manuel Produit page 23

User and installation manual RA 18
6. The control panel switches to active mode after the preset time, bathing temperature and bathing time have been
set. In the active mode, the sauna heater functions as follows:
•
If the preset time is default 0.00 (i.e. not changed in the setting mode),
the sauna heater will turn on immediately and the temperature display
shows the current temperature of the sauna room while the time display
shows the remaining bathing time.
•
If the preset time is not 0.00 (i.e. the default setting has been changed in
the setting mode), the control panel switches to the preset mode. In this
mode, the upper display shows three bars (- - -) and the lower display
shows the remaining preset time. The dot between hours and minutes in
the time display flashes to indicate that the preset mode is activated.
Once the preset time has elapsed, the sauna heater will turn on and start
heating up.
Some useful tips:
•
The sauna heater / control panel can be switched off at any time by
pressing the On/Off button.
•
You can speed up the selection of setting values by keeping the button
+ or – pressed.
•
If the settings stored in the memory (bathing temperature and time) are
applicable, you can turn the sauna heater on simply by pressing the On/Off
button of the control panel. The control panel displays the settings and starts
the sauna heater automatically, if no buttons are pressed.
The control panel is able to display certain malfunctions:
The control panel is able to display certain malfunctions that may arise while using the sauna.
These are the corresponding error messages:
Err 1 Overheating protection activated
Err 2 Sensor malfunctioning
Err 3 Serial traffic between the sauna heater and the control panel is not working
These malfunctions must be repaired by a qualified technician.
Please contact the nearest authorised repair shop.
All manuals and user guides at all-guides.com
4