Télécharger Imprimer la page

Black & Decker FIRE STORM FS300DP Manuel D'instructions page 11

Publicité

Les langues disponibles

Les langues disponibles

LOCKING SWITCH IN THE "OFF" POSITION
IMPORTANT: When the machine is not in use, the
switch should be locked in the "OFF" position to
prevent unauthorized use. This can be done by
grasping the switch toggle (B) and pulling it out of the
switch, as shown in Fig. 19. With the switch toggle (B)
removed, the switch will not operate. However, should
the switch toggle be removed while the drill press is
operating, the switch can be turned "OFF" once, but
cannot be restarted without inserting the switch toggle
(B).
FLEXIBLE LAMP
WARNING: The flexible lamp operates independently
of the drill press. To turn the lamp "ON" and "OFF",
rotate switch (A) Fig. 19A.
To reduce the risk of fire, use 40 watt or less, 120 volt,
reflector track type light bulb (not supplied). A standard
household light bulb should not be used. The reflector
track type light bulb should not extend below the lamp
shade.
TABLE ADJUSTMENTS
1. The table can be raised or lowered on the drill
press column by loosening the table clamp (A) Fig. 20,
and turning the table raising and lowering handle (B)
Fig. 21. After the table is at the desired height, tighten
clamp (A) Fig. 20. NOTE: Final positioning of the drill
press table should always be from the bottom to the up
position.
2. The table can be rotated 360 degrees on the
column by loosening clamp (A) Fig. 20, rotate table to
desired position and tighten clamp (A).
B
A
11
Fig. 19
A
Fig. 19A
Fig. 20
Fig. 21
B

Publicité

loading