Publicité
Les langues disponibles
Les langues disponibles
GENERAL SPECIFICATIONS
UNIT COMPONENTS
1. CABINET FOR THE OUTDOOR UNIT
The cabinet housing the outdoor unit is made from galvanised sheet metal hot-painted with polyester powders after pas-
sivation treatment. This makes it resistant to atmospheric agents. The bearing structure is in very thick press-moulded
galvanised sheet metal giving overall rigidity and preventing vibrations from being transmitted.
2. CABINET FOR THE WALL INDOOR UNIT
The cabinet housing the wall indoor unit is entirely made of ABS and also acts as a bearing structure.
3. COMPRESSOR
The compressor in the outdoor unit is the highly efficient and silent ROTARY type, with protection against both thermal
and electrical overloads. It is fitted on rubber supports to eliminate faults due to vibrations.
4. VENTILATING UNIT
The ventilating unit of the wall unit consists of a tangential fan. This ensures very silent running. The outdoor unit is pro-
vided with a helical fan with large blades.
5. HEAT EXCHANGE BANK
In both units the heat exchange bank is made of copper tubing with aluminium sheet fins in a continuous pack. The fins
are directly blocked by the mechanical expansion of the copper tube in order to obtain a high degree of heat
transmission.
6. COOLING CIRCUIT
This is achieved using a copper tubes with seal-tested connections.
7. FILTERING SECTION
The filtering section, located in the indoor unit, is made of synthetic material with a high filtering capacity and can be
regenerated by blowing and washing it.
8. REMOTE CONTROL
The air conditioners of this series are provided with an infrared remote control, which allows the appliance to be easi-
ly operated and all parameters controlled.
8
Publicité
