Publicité
7
8
9
12
4 mm
1
2
1
2
4
English
Open the stops using a 4 mm Allen wrench
(1).
Open the stops (1).
Install the carrier plate (2).
Install the carrier plate screws.
All models except Citterio:
Remove the disk.
Citterio only:
Place the handle over the stem (1).
Turn the handle counter-clockwise as far as it
will go (2).
3
Measure the temperature of the output water
(3).
Turn the water off.
Remove the handle (4).
Do not remove the disk.
If the valve opens through hot,
reverse the cartridge. See page
16.
If the max. high temperature is
greater than 120°F adjust the
rotational limit stop. See page
18.
Publicité
