Hiltron security XR400 Mode D'emploi page 4

Doble zone radio burglar system with integrated siren
OPERATING
The slow flashing of the LED (one flash every 3 seconds around) under the lamp signals that the siren is activated. The
fast flashing of the LED signals a power supply anomaly and that proper operating of the acoustic and visual signalling aren't
availables; in this case you have to check all devices power suppliers and particularly internal battery level.
If the LED doesn't flash, the central unit isn't in operating mode and so, that it is disabled for a power supply absence.
Using XR20 remote control to enable the central unit. Using red button to enable XR400. The proper enabling is
signalled by 3 flashes of the lamp.
If the central unit will be enabled, every alarm events will be transmitted by the sensors or the sabotage of these one will
activate an alarm cycle signalled for 5 minutes by the internal siren or by others XR300 sirens connected. To disable the alarm
cycle, press the green button of remote control.
After an alarm cycle, an alarm event is displayed by a flash of the lamp every 5 seconds. This is deleted by each central
unit insertion or it can be deleted pressing the red button of XR20 remote control.
Press the green button of XR20 to disable the central unti: a long flash of the lamp signals that the XR400 is diabled. In
this condition, XR400 can signal only a sabotage of the central unit or connected devices acivating for 3 minutes the internal
siren (all other connected sirens are denabled). During a sabotage, you can disable the siren by the red button of XR20
remote control or enabling the central unit pressing the re3d button of re control. The alarm memory is enabled even if the
central unit is disabled. An alarm event is signalled by a flash of the lamp every 5 seconds, and it's deleted enabling the central
unit. To enable power supply absence signalling, open the jumper near the fuse; if the system is disabled by power supply
absence, the siren will activate every 4 hours for an alarm cycle of 30 seconds.
CONNECTIONS
Disconnecting
Switch
230V~
50Hz
4
10(+) 12(-)
2 4
To the battery
12V2,2Ah
security
XR400