Publicité
Les langues disponibles
Les langues disponibles
LIGHTING INSTRUCTIONS
Using the Igniter
1. Read and understand all operating instructions before lighting.
2. Before beginning, make sure the control knob is in the OFF position.
3. Connect your propane cyliner (see previous pages).
4. Slowly open the valve on your LP cylinder.
5. Prepare to ignite your fire table by placing one hand on the control knob
and one hand on the ignition button (as seen in diagram on the right).
DO NOT lean over any part of the burner, and verify that the area around
the burner is free of hazards.
6. Push and hold the igniter, you should hear a clicking sound.
7. While holding the igniter depressed in one hand, use your other hand to
push in and turn the control knob to the LIGHT position.
8. Once the burner ignites, release the igniter button, but continue to keep
the control knob pushed in for 15-30 seconds.
9. WARNING: If ignition does not occur in 30 seconds, turn the control knob to the "OFF" position and turn the
gas off at its source. Make sure there is no source of ignition around the fire table and wait at least five
minutes until the gas has cleared to repeat the lighting procedure. Failure to do so could result in a large
flashback of pooled gas, causing property damage or injury.
10. After successfully lighting the table, release the control knob and turn it to the LOW setting. Observe the
flame and make sure that all burn ports are lit.
11. Adjust the flame to the desired height using the control knob.
Push Control
Shut-off Instructions
1. Turn the control knob to the OFF position.
2. Close the valve on the LP tank to shut-off gas flow.
Knob In
Flame Height
1 1
8-14"
20.3-35.5 cm
Publicité
