Publicité
Les langues disponibles
Les langues disponibles
Operation
Using the dryer
1. Open the door,
i
2. Check lint filter,
The filter should be cleaned after
and before every drying process.
Cleaning the filter reduces the
drying time and saves energy,
[_
Bleach may cause discoloration of
the dryer's colored surface,
Therefore, it is important to keep
the bleach away from the colored
surface of your dryer, If any bleach
spills on the surface, use a moist
paper towel to thoroughly clean it
immediately.
Permanent Press
Regular/Cotton
ECOSENSOR
Off
ECOSENSOR
Damp dryl!
Regu ar dry
_t,
Damp dry
w.o,...o\\I Ii ///vorydry
S
3. Rotate program selector to the
desired program,
Select the program which
corresponds to the laundry in the
dryer from the program selection
table (see page 17),
The dryer light turns on inside the
drum.
[_The
"Start/Stop" indicator light
starts flashing,
[_The
estimated
remaining time will
be indicated.
Start i11
Beady in
1'
Menu
Select
addiUonal options
4. Select "Additional Options" on the
display.
More detailed information on the
individual additional options can
be found on page 15,
5. If required, select "Option" by
pressing the button.
The "Options" are explained on
page 16.
[_The
estimated remaining time will
be updated.
6. Place laundry in the empty drum.
Put each piece of laundry into the
machine separately.
For best results the laundry to be
dried must be sorted according to
type of laundry and desired degree
of drying, For further information
see page 14.
[_
Observe drying symbols of the
laundry manufacturer.
If drying woolen clothing and
shoes, see the information on
page 66 and page 19,
Ensure that there is only laundry in the
drum. Check that all items are
completely in the drum.
7. Close the door.
The "Start/Stop" indicator light
continues flashing.
[_lf
you have chosen a time program
don't forget to select a time.
Otherwise the "Start/Stop"
indicator light will not flash and the
dryer will not start,
[_lf
the door has not been closed
properly, the dryer will not start,
8. Press the "Start/Stop"
button. The
"Start/Stop" indicator light
illuminates.
[_The
program starts with an
acoustic signal (if set),
If an automatic program has been
selected, the indicator lights indicate
the progress of the program sequence.
[_At
the end of the program
sequence Damp dry an acoustic
signal is emitted (if set),
OLint filter
At program end an acoustic signal
is emitted (if set) and the LED
"Wrinkle block" illuminates.
When the drying process is
complete (program or selected
time program ended), the drum
rotates at specific intervals, This
prevent the laundry from creasing
(see "Extended Wrinkle Block",
page 16).
18
Publicité
