- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
to clean the appliance.
- Do not submerge the appliance in water or any
other liquid, or place it under a running tap.
- Never submerge the connector in water or any
other liquid or place it under running water.
- Next dry all the parts before fitting them together
and storing.
- To ensure optimum quality ice cubes, the water
PROBLEM
The compressor is beha-
ving strangely and makes a
buzzing sound.
The "Water tank empty" icon
appears
Despite following all of the
instructions, no ice is being
produced.
The "Tank empty" and "Tray
full" icons appear at the same
time.
FOR EU PRODUCT VERSIONS AND/OR IN
THE CASE THAT IT IS REQUESTED IN YOUR
COUNTRY:
ECOLOGY AND RECYCLABILITY OF THE
PRODUCT
- The materials of which the packaging of this
appliance consists are included in a collection,
classification and recycling system. Should you
wish to dispose of them, use the appropriate
public containers for each type of material.
- The product does not contain concentrations of
substances that could be considered harmful to
the environment
This symbol means that in case you wish
to dispose of the product once its
working life has ended, take it to an
authorised waste agent for the selective
collection of waste electrical and
electronic equipment (WEEE)
should be changed every 24 hours.
FAULTS AND REPAIR
- Take the appliance to an authorised technical
support service if problems arise. Do not try to
dismantle or repair it, as this may be dangerous.
- If any anomaly is detected, check the following
table:
POSSIBLE CAUSES
Mains voltage is lower than that
recommended
The water tank is empty
There is air in the water pump
No refrigerant in the freezer
circuit or the fan motor is dama-
ged.
It is possible that the ice cube
ejector may be blocked.
This appliance complies with Directive 2014/35/
EU on Low Voltage, with Directive 2014/30/EU
on Electromagnetic Compatibility, with Directive
2011/65/EU on restrictions on the use of certain
dangerous substances in electrical and electronic
appliances and with Directive 2009/125/EC on
the ecological design requirements applicable to
products related to energy.
POSSIBLE SOLUTIONS
Do not plug the appliance into
the mains supply if the voltage
indicated on the nameplate does
correspond the mains voltage.
Switch the appliance off, fill the
tank and wait 3 minutes before
switching the appliance back on
again.
Remove the silicone plug and
allow a few drops of water to
escape.
Contact your distributor or
after-sales service to have them
replaced.
Switch off and unplug the
appliance to remove the ice
cubes Switch the appliance back
on again.