Black & Decker BHRO608 Mode D'emploi page 8

SET UP & USE
OPERATING INSTRUCTIONS
Place the heater on a firm, level surface and plug the unit directly into a 120 V AC
electrical outlet.
NOTE: Only operate heater in upright position.
1. Carefully remove the heater from its carton and bag.
2. Make sure the heater is located on a flat and stable surface prior to turning it on.
Damage and automatic shut-off may occur if the heater is located on an incline.
3. Make sure all the control knobs are in the OFF position, then plug the heater in a
functional polarized outlet. Make sure the plug is inserted fully in the outlet. Select
the power setting as instrcted below.
4. To turn the heater off, turn both the control knobs to the OFF position then unplug
the heater from the outlet.
Power settings
Turn the power knob to the desired setting.
1. is for low power (400 watts) without oscillation.
is for high power (800 watts) without oscillation.
2.
is for low power (400 watts) with oscillation.
3.
4. is for high power (800 watts) with oscillation.
5. To turn to heater off, turn both control knobs to
the OFF position then unplug heater from outlet.
Page 8