Publicité
Les langues disponibles
Les langues disponibles
Whilst charging, the blue LED light of your straightener, indicating the battery of the
device, will be illuminated. Once the blue LED light goes off, that means your straightener
is fully charged and is ready for use.
Please note:
Your straightener comes with a charging stand as well as a UK/EU charging adaptor and a
separated USB charging cable. You can charge your Liberate Cordless straightener:
•
using the UK/EU charging adaptor with the USB-C end plugged into the
straightener.
•
using the UK/EU adaptor plugged into the charging stand. In this case, the blue
LED light on the charging stand will remain static whilst the blue LED light on the
straightener will flash until fully charged. Once fully charged, the blue LED light on
the straightener will stay on for approximately 5 minutes and then switch off.
•
using the USB charging cable plugged into any USB compatible device with the
USB-C end plugged into the straightener.
•
using the USB charging cable plugged into any USB compatible device with the
USB-C end plugged into the charging stand. In this case, the blue LED light on the
charging stand will remain static whilst the blue LED light on the straightener will
flash until fully charged. Once fully charged, the blue LED light on the straightener
will stay on for approximately 5 minutes and then switch off.
•
Please note that the charging time will be longer if you choose to charge your
straightener using the charging stand instead of directly using the charging cable. The
charging time if using the charging stand is around 3 hours 30 minutes.
•
Please note your straightener will not function whilst charging on the stand.
•
While styling your hair you can return your straightener to the charging stand but
please note that the straightener will only recharge when it has been turned off.
•
Warning: If the charging light suddenly starts to flash rapidly then the appliance is
faulty. If this happens, please stop charging and remove the adaptor from the mains
and contact our Customer Care Centre for further advice.
INSTRUCTIONS FOR USE
•
Before use, ensure the hair is clean, dry and tangle-free.
•
For extra protection, apply a heat protection spray.
•
Section the hair prior to styling. Style the lower layers first.
•
Plug the product into a 220-240V mains power supply.
•
Please make sure that the Travel Lock
•
Press and hold the POWER button
default temperature when the product switches on is 210°C. There are 4 temperature
settings 170°C, 190°C, 210°C, and 230°C, indicated by a white LED light according to the
temperature selected.
•
Press the POWER button
light indicating the temperature setting selected will gradually move up as you press
the POWER button.
•
REVAMP recommends starting on the lowest setting on initial use and increase the
temperature until the desired result is achieved. If you have fine, delicate hair, use the
lower heat settings. If you have thick or coarse hair, use the higher heat settings.
•
The selected digital temperature display will flash until the straightener has reached
the desired temperature. Once the temperature has been reached, the white LED light
will remain static.
•
Working on one section at a time run the straightener through the entire length of
the hair from roots to ends, without stopping. Use a comb while straightening for even
straighter results.
•
Repeat this process all over the head, allowing hair to cool before combing through.
•
IMPORTANT! When using the straightener, take care not to place it too close to face,
ears, neck or skin.
•
After using the straightener, switch off, unplug, place on the product stand or a heat
resistant surface and allow to cool before storing away. For extra safety, reapply the
Travel Lock.
•
Please note: When the product runs out of battery, it will turn itself off with an audible
"beep" signal.
is unlocked before use.
for 2 seconds to switch on the product. The
again to select your desired temperature. The white LED
Publicité
