Avintage AVU8TXA Notice D'utilisation page 54

AVU18TDZA AVU23TXA(/IX) AVU52TXA(/IX) AVU54TXDZA
1. Lower hinge (right)
4. Door
7. Top hinge (left)
10. Door limit device
1. Open the door to 90 degrees, remove the two screws (2) from the lower door axis (3), remove the door
(4) and door axis (Fig. A).
2. Position the door (4) safely and remove the plug from the top of the door frame. Unscrew one screw
(11) at the bottom and remove the door limit device (10). Install the door limit device (10) at the top of
the door frame. Please use the spare plug to block the hole at the top of the door frame (Fig. A/B).
3. Take out three hinge screws (6) from the upper hinge (right) (5) and remove it (Fig. C).
4. Remove the decorative nail (8) from the top left of the cabinet and install the spare top hinge (left) (7)
on the top left of the cabinet with three screws (Fig. D).
5. Install the spare lower hinge (left) (9) according to the above procedure (Fig. E).
6. The door opens to 180 degrees. Install the door in the same way as it was removed and fix it so that
the door is aligned.
7. Block the hole at the top right of the cabinet with the spare decorative nail (8).
2. Screws
5. Top hinge (Right)
8. Decorative nail
11. Screw
3. Door axis
6. Hinge screws
9. Lower hinge (left)
54