Publicité
Les langues disponibles
Les langues disponibles
English
Technical Information
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Max. flow rate
04370XX0, 04371XX0,
04510000, 31539001
31920XX1
Hole size in mounting surface
Max. depth of mounting surface
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
• The drain is intended for use in a sink with an
overflow. If your sink does not have an overflow,
or if this drain is too small for the hole in your sink,
please refer to the instructions included with the
sink. Some sinks include special drain installation
instructions and/or parts. Others require the use of
a specialty drain. Hansgrohe is not respnsible for
the cost of a specialty drain.
• 04510000, 31539001 only: This faucet does
not include a drain or a pull rod.
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
1.2 GPM (4.5 L/min)
2.2 GPM (8.3 L/min)
1½" (38 mm)
1⅛" (30 mm)
• Model #31920XX1 only: The discharge water
temperature from a bidet fitting shall be limited to a
maximum temperature of 110ºF (43ºC) by a water
temperature limiting device conforming to ASSE
1070.
• The hot and cold supply hoses included with this
faucet are for use with ⅜ stops. If your stops are
a different size, install new stops. Adapters are not
available from Hansgrohe.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
Publicité
