Volts: 120 A.C. only. Hertz: 60
The power rating for your Stand Mixer is
printed on the trim brand or on the serial
plate.
Model KSM7990 Only:
Volts: 120 V
Hertz: 60 Hz
Wattage: 500 W
Horsepower: 1.3*
Do not use an extension cord. If the
power supply cord is too short, have
a qualified electrician or serviceman
install an outlet near the appliance.
A short power supply cord (or detachable
power supply cord) should be used to
reduce the risk resulting from becoming
entangled in or tripping over a
longer cord.
Please read the following before
calling your service center.
1. The Stand Mixer may warm up during
use. Under heavy loads with extended
mixing time periods, you may not be
able to comfortably touch the top of
the Stand Mixer. This is normal.
2. The Stand Mixer may emit a pungent
odor, especially when new. This is
common with electric motors.
3. If the flat beater hits the bowl, stop
the Stand Mixer. See "Beater to
Bowl Clearance".
* Motor horsepower for our mixer motors was measured using a dynamometer, a machine
laboratories routinely use to measure the mechanical power of motors. Our 1.3 horsepower (HP)
motor reference reflects the horsepower rating of the motor itself and not the mixer's horsepower
output to the mixer bowl. This robust motor, the backbone of our new mixer, delivers .44 HP to
the bowl, enabling your mixer to deliver consistent power to small and large loads with less heat
build-up; resulting in years of dependable mixing. When combined with and guided by our new
advanced motor control board, this is our longest lasting and most efficient motor yet. Simply put,
our new, highly efficient, special purpose motor delivers the power you need when you need it.
Electrical Requirements
Troubleshooting Problems
If your Stand Mixer should
malfunction or fail to operate,
please check the following:
- Is the Stand Mixer plugged in?
- Is the fuse in the circuit to the Stand
Mixer in working order? If you have a
circuit breaker box, be sure the circuit
is closed.
- Turn the Stand Mixer off for 10-15
seconds, then turn it back on. If the
mixer still does not start, allow it to
cool for 30 minutes before turning it
back on.
If the problem is not due to one of
the above items, see the KitchenAid
Warranty. Do not return the Stand
Mixer to the retailer, as they do not
provide service.
7