Pattfield Ergo Tools PE-260DS Traduction De La Notice Originale page 72

Product overview
1 On / Off switch
2 Sanding pad
3
Power cord
4
Speed dial
5 Dust port
Intended Use
The tool is intended for dry sanding of wood,
plastic, metal, filler as well as coated surfaces.
The tool is not intended for commercial use.
Any other use or modification to the tool is
considered as improper use and could cause
considerable dangers.
Technical Data
Nominal voltage
Rated power
No-load speed (n )
0
Size of base plate
Weight
Protection Class
Sound pressure level (L
Sound power level (L
Max. vibration emission (a
DUST COLLECTION SYSTEM
1 Insert the vacuum adaptor into the dust
port 5. Lock the vacuum adaptor in
place by turning it clockwise.
70 EN
)
pA
)
wA
)
h,ID
Using the tool
1. Place the tool on the workpiece so that
the complete sanding paper is in contact.
Make sure your workpiece can not slip.
2. To switch on the tool, switch on the on /
off switch 1. Start working, while holding
the tool firmly with both hands.
3. Move the tool slowly over the workpiece
in parallel lines, circles or crosswise
movements and successive passes.
4. To switch off the tool, switch off the on /
off switch 1.
Warning! Only switch the tool on
when the sanding paper is in full
contact with the workpiece.
230 V / ~50 Hz
260 W
6000 - 11000/min
92 x 92 x 92 mm
1.22 kg
/ II
83 dB(A) / Uncertainty K = 3 dB(A)
94 dB(A) / Uncertainty K = 3 dB(A)
6.353 m/s / Uncertainty K = 1.5 m/s
2
2 The 35 mm vacuum adaptor can be
reduced to 32 mm by use of the adap-
tor reducer.
Never use the tool without a dust
collection system.
2