Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PRODUCT SPECIFICATIONS
Dual Power ....................... 18 Volt Battery/12 Volt Adaptor
LEDs ..................................................................................
WARNING:
Do not direct the light beam at persons or animals and
do not stare into the light beam yourself (not even from a
distance). Staring into the light beam may result in serious
injury or vision loss.
WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
NOTICE:
Operate in a well ventilated area. Do not block vents.
Keep them clear to allow proper ventilation.
APPLICATIONS
You may use this product for the purpose listed below:
To illuminate distant objects and areas requiring
additional light
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 6.
Insert the battery pack as shown.
Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured in the
product before beginning operation.
Depress the latches to remove the battery pack.
NOTE: This product is designed to be powered by either a
Ryobi One+ 18 Volt battery pack or 12 Volt power source as
described in this manual.
If the light flashes during operation, try recharging and rein-
stalling the battery pack.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
FEATURES
Light Output ................................................. 2,500 Lumens
Runtime (approximate) .................................. Up to 5 hours
7
OPERATION
WARNING:
Battery products are always in operating condition. There-
fore, remove the battery pack when the product is not in
use or when carrying at your side.
12 VOLT ADAPTOR
See Figure 2, page 6.
The spotlight may be connected to a 12 Volt power source,
such as a cigarette lighter receptacle or automotive power
port.
Refer to the operator's manual for the vehicle or contact the
vehicle manufacturer for the proper power receptacle. This
product may not be suitable for being powered through the
auxiliary power outlet.
Insert the barrel plug into the port.
Secure the cord in the cord retainer.
Route the cord to the 12 Volt power source.
Hold the 12 Volt adaptor firmly and place connector into
the auxiliary power outlet.
WARNING:
If the 12 Volt adaptor does not fit firmly into the auxiliary
power outlet, the outlet may not be suitable for use with
this product.
TURNING THE SPOTLIGHT ON AND OFF
See Figure 3, page 6.
The spotlight has three settings: high, low, and off.
High: Press and release the switch trigger once.
Low: Press and release the switch trigger twice.
Off: Press and release the switch trigger a third time.
4 — English
Publicité
Table des Matières
