Publicité
'
1. Final gear oil
2. Final gear oil filler bolt
3. Correct level
1. Huile de transmission finale
2. Boulon de remplissage d'huile de transmission finale
3. Niveau correct
1. Aceite de la transmisión final
2. Perno de relleno de aceite de la transmisión final
3. Nivel adecuado
12. Start the engine and warm it up for several
minutes. While warming up, check for oil
leakage. If oil leakage is found, turn the en-
gine off immediately and check for the cause.
13. Turn the engine off, and then check the oil
level and correct it if necessary.
14. Install panel F.
Final gear oil
Final gear oil measurement
1. Place the machine on a level surface.
2. Remove the oil filler bolt, and then check the
oil level in the final gear case.
NOTE:
_
The oil level should be at the brim of the filler hole.
_
3. If the oil is below the brim of the filler hole,
add sufficient oil of the recommended type to
raise it to the correct level.
CAUTION:
_
Be sure no foreign material enters the final
gear case.
_
4. Install the oil filler bolt.
8-41
EBU11452
Publicité
