Tefcold SE10-45 Mode D'emploi page 11

The display will return to normal reading after 15 sec.
See table of parameters from page 29.
Alarm codes:
P1
Flashing in the display: indicates that the cabinet sensor is defective.
The cabinet will strive to keep the set temperature until it has been repaired.
HA Flashing in the display: indicates that the temperature is too high.
LA
Flashing in the display: indicates that the temperature is too low.
Thermostat Carel
Display set temperature:
Press this key and the display will show the set temperature. Press the key again to return
to normal reading.
Set new temperature:
Press this key and the display shows the set temperature.
Press this key to increase the set temperature.
Press this key to lower the set temperature.
Press this key to save the new settings. The display will flash with the new value and will
then return to normal reading.
11