Publicité
Les langues disponibles
Les langues disponibles
Installation
B
STEP 5 Powering your washer
26 English
WA8700K_WA50K-03647A-01_EN.indd 26
3. If the washer is level, the pulsator (A) is
positioned at the center of the water as
shown in the figure.
If not, level your washer by turning
the front leveling feet clockwise or
counterclockwise as necessary.
NOTE
Turn the front leveling feet clockwise (B) to
lower the washer, and counterclockwise (C)
to raise the washer.
C
Plug the power cord into a 3-prong,
well grounded 120 volt 60 Hz approved
electrical outlet protected by a 15-amp fuse
or comparable circuit breaker.
Your washer is grounded through the third
prong of the power cord when plugged into
a three-prong grounded electrical outlet.
Test run
Make sure that you install your washer
correctly by running the Rinse+Spin after
the installation is complete.
2016/1/13 16:49:57
Publicité
