Cleaning & Maintenance - Honeywell CS10XE Manuel Du Propriétaire

CLEANING & MAINTENANCE
WARNING
•
Before cleaning the unit, switch it to the OFF position and
remove the plug from the power socket.
•
To clean the outside, use a damp cloth to remove dirt and
dust.
•
Never use corrosive elements or any chemicals to clean
this product.
•
When the product is not in use, store the unit in a dry place
out of direct sunlight.
CLEANING & DRAINING THE WATER TANK:
•
Turn the power OFF and disconnect the air cooler from the
power supply.
•
Move the unit to a location where it can be drained. Remove
the cap from the drainage tube and allow the tank to empty
(see parts description on page 7).
•
Once the tank is empty, unlock the latches on both sides
and lift off the cooler top section as shown in the figure and
place it vertically on the floor. Be careful not to bend the
water pickup tube that hangs below the unit.
•
Refill the water tank with clean water and drain it completely.
Clean the water tank with detergent or a damp cloth and
•
rinse it thoroughly.
Place the unit top carefully on the tank and lock the latches.
•
Refill the water tank with clean water, up to the maximum level.
The air cooler is now ready to be used. This cleaning
process should be repeated weekly to maintain the integrity
of the unit and to remove particles filtered from the air.
14
Water Pick Up Tube
Detached Water Tank