Warranty Conditions - Stab SELFSAT-ROTOR HH90 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Warning
Only a specialist can guarantee a correct mechanical installation which will avoid damage or serious
injury.
The motor must not be mounted upside-down.
For mounting, all the screws and nuts contained in the kit must be used. The absence of one screw or nut
may cause instability or the fall of the equipment.
The motor has been tested for resistance in wind conditions of 140 Km/h with a dish of 100 cm, so care
must be taken in choosing the supporting pole and its anchorage. If possible, installation should be carried
out in a place sheltered from wind (rooftops are never advisable).
The use of dishes with a larger diameter than that indicated in the specifications for each motor is strictly
prohibited.
The motor, being a mechanical rotating instrument, must be installed out of reach of people.
The motor must not be used for purposes other than those indicated by STAB.
The motor has been designed to be supplied by a sat receiver or by a STAB positioner; any other type of
supply is strictly prohibited and may cause damage or serious injury.
Some receivers have an anti-disturbance system linked to the body of the connector F. This may provoke
a slight electric shock not dangerous for the user. In particular conditions (e.g. on a roof or on a staircase) it
may cause falls or injuries. Each time the motor is handled the receiver must be disconnected from the
outlet.

Warranty conditions

This rotor is produced and tested by our laboratory with extreme care and carries a warranty for 36 months
from purchase date. A copy of the shop receipt or the invoice represent the warranty document and must be
sent together with the set when returned. This warranty covers all production defects and working faults, but
excludes all damages caused by drops, incorrect use or external oxidations due to incorrect installation. Any
repair made by unauthorised personnel will automatically cancel this warranty.
PLEASE FILL IN THIS FORM WITH THE SERIAL NUMBER OF THE
MOTOR IN CASE OF AFTER SALES OR TECHNICAL ASSISTENCE.
Information
6
For further information and advice about installation and uses contact:
YOUR LOCAL DEALER or:
Midi France Distribution ZA de Fontvieille Route des 4 Saisons
13190 ALLAUCH - FRANCE
Tel: +33 - (0)4 91 07 50 50
IDOIT
selfsat@mfdis.com
SERIAL NUMBER

Publicité

Table des Matières
loading

Table des Matières