Stab SELFSAT-ROTOR HH90 Mode D'emploi page 3

The USALS installation procedure is extremely simple. If you are not absolutely certain
of the coordinates and the degrees of elevation of the antenna for your installation
location, consult the site: www.stab-usals.us or the maps at pages 27-35.
STAB will provide you with all the data of: Latitude, Longitude, Dish Elevation.
1
In order to obtain a correct pointing of the satellites,
all system must be in a perfect plumb line.
3
15mm
8mm
3mm
LNB
REC
30 cm
CONNECTOR COVER
- On a coaxial cabel approximately 1,5 m long, set up 2 F-connectors.
- Connect the antenna to the rotor's LNB plug.
- Fit an F-connector on each end of the cable going to the reciver and
connect the rotor's REC plug to the plug of the receiver.
F CONNECTOR
TV
LENGTH: up to 30 m
Resistence= 18 Ω/Km (max)
Ø=1,02mm
Resistence= 22 Ω/Km (max)
2
LATITUDE
10° ÷ 45°
Nut
Clamps
U bolt
RECEIVER
Cable 2
RECEIVER
Scart
Characteristics of the coaxial cable
Ø=1,13mm
LATITUDE
45
Bracket
Screw + nut
Minimum height
to avoid vibration
ROTOR ANTENNA
LNB
REC
Cable 1
Cable 2
LENGTH: from 30 m to 60 m
Resistence= 10 Ω/Km (max)
Resistence= 18 Ω/Km (max)
° ÷ 70°
Cable 1
3