Publicité
Les langues disponibles
Les langues disponibles
3. Mount the two swivel casters with brake to the rolling
cabinet using four bolts (CC) and washers (BB) per
caster. The swivel casters with brake should be in-
stalled on the end of the cabinet with the side handle.
4. Mount the two rigid casters to the opposite end
of the rolling cabinet using four bolts (CC) and
washers (BB) per caster.
5. Tighten all bolts securely with a wrench.
6. Return the rolling cabinet to its upright position.
BB
CC
Installing the Chest onto the Cabinet
Two people may be required to
CAUTION
complete installation.
1. Place the top chest on top of the rolling cabinet.
NOTE: The holes in the cabinet are tapped and
do not require nuts.
2. Attach the two brackets to the back of the product
to secure the top chest to the rolling cabinet. Place
the brackets over the holes and secure with four
screws (DD) per bracket.
3. Tighten all screws securely with a Phillips screw-
driver.
DD
Installing the Drawer Liners and Mat
Place the drawer liners in appropriately sized draw-
ers and the mat in the chest lid area to protect the
surface.
Installing the Corner Extrusions
and Bumpers
Place the front bumpers on both ends of the extrusion
by sliding the extrusion into the cavity of the bumpers.
Attach the front bumpers with extrusions using two
screws (FF) per bumper.
Attach the two rear bumpers to the back of the lower
cabinet using two screws (FF) per bumper.
Installing the Cord Storage Brackets
Attach the brackets to the back of the chest and
cabinet with two screws (DD) per bracket. Orient the
brackets with one pointed up and one pointed down
so that the power outlet cord can be wrapped around
the brackets for storage.
Installing the Storage Shelf
Attach the shelf hinge brackets to the right cabinet
using two bolts (AA) for each bracket. Attach the
storage shelf to the brackets using one washer (II),
nut (GG) and bolt (HH) on each end.
Installing the Tool Hanger
Attach the tool hanger to the left end of the chest
using two bolts (AA).
Installing the Utility Hooks and
Paper Towel Holder
Attach the utility hooks and paper towel holder to
either end of the chest using two screws (EE) for
each hook and bracket.
Installing the Bottle Opener
Attach the bottle opener to the left side of the cabinet
using two screws (JJ).
5
FF
AA
GG
HH
II
Publicité
