Uline HEX H-2560 Mode D'emploi page 3

7. Align slots on underside of tabletop with center
support beams. Ensure the support beams are
centered. (See Figure 7)
Figure 7
Tabletop
8. Remove support item from under table. Ensure
tabletop and bases are level and resting flat on
mounting surface.
9. Once level, secure tabletop to vertical supports using
3½" hex lag screws and washers. (See Figure 8)
Figure 8
Tabletop
PAGE 3 OF 9
ASSEMBLY CONTINUED
3½" Hex Lag Screw
Washer
Vertical
Support
1-800-295-5510
10. Secure anchor blocks to base seat supports using
2½" hex lag screws and washers. (See Figure 9)
Figure 9
2½" Hex
Lag Screw
11. Make sure table is level and tighten all screws.
NOTE: H-2565 mounting hardware sold
separately.
uline.com
Washer
0623 IH-2560