Télécharger Imprimer la page
Les langues disponibles

Les langues disponibles

Liens rapides

H-7930
TERRACE BENCH
WITH BACK
TOOLS NEEDED
Hammer
1.
Place bench where it is intended to be mounted.
2. Mark drill points on ground through bench feet.
3. Drill 3/8" holes into concrete with masonry bit.
(See Figure 1)
IMPORTANT! Minimum depth of 4" of concrete
is necessary for surface mounting.
4. Clear holes of dust and debris.
Figure 1
PAGE 1 OF 3
1-800-295-5510
uline.com
Drill
Masonry
Drill Bit
Washer x 4
Nut x 4
Adjustable
Wrench
PARTS
Wedge Anchor x 4
MOUNTING
5. Align holes in bench feet with drilled holes in
concrete.
6. Place washer then nut on the edge of wedge
anchor (protects threads during installation).
7.
Hammer wedge anchor into hole deep enough
so that threads are below surface of base material.
(See Figure 2)
8. Tighten hex nut on anchor mount. (See Figure 2)
Figure 2
Para Español, vea página 2.
Pour le français, consulter la page 3.
1122 IH-7930
loading

Sommaire des Matières pour Uline H-7930

  • Page 3 H-7930 1-800-295-5510 uline.ca BANC DE TERRASSE AVEC DOSSIER OUTILS REQUIS Marteau Perceuse Mèche à Clé à molette maçonnerie PIÈCES Rondelle x 4 Écrou x 4 Ancrage à clavette x 4 INSTALLATION Placez le banc à l'endroit où il doit être installé.