Publicité
Step 6
å
Flip the the MODESTY PANELS (G and O) over.
å
Turn eight BLACK 9/16" FLAT HEAD SCREWS (32S) into the MODESTY PANELS (G and O) until the shoulders of the
SCREWS rest on the surfaces of the MODESTY PANELS.
å
NOTE: Do not overtighten the SCREWS.
å
Slide the LONG MODESTY PANEL MOLDINGS (L) onto the MODESTY PANELS (G and O). Line up the groove in the
MOLDING over the heads of the SCREWS in the MODESTY PANEL.
å
NOTE: Be sure the MOLDINGS are positioned exactly as shown. If the MOLDINGS come up off of the SCREWS, remove
them and slide them on again. The MOLDINGS should be centered over the MODESTY PANELS.
BLACK 9/16" FLAT HEAD SCREW
(8 used in this step)
L
Page 12
32S
O
G
L
Angled edge
Apply pressure with your hands as you
guide the MOLDINGS over the SCREWS
and onto the ENDS, UPRIGHTS, and BACKS.
Apply pressure with your hands as you
guide the MOLDINGS over the SCREWS
and onto the ENDS, UPRIGHTS, and BACKS.
428728
Shoulder
Angled edge
Shoulder
www.sauder.com/service
Publicité
