Publicité
Step 17
å
IMPORTANT: Skip this step if you did not purchase the
428725 Hutch.
å
Locate the TOP (X) and RETURN TOP (Y) and lay them on
packing foam or magazines flat on the floor as shown.
å
With a drill and 3/16" drill bit, finish drilling through
the four holes shown based on your Diagram 1 or 2
preference in Step 16.
Drill through these two small
holes for Diagram 2 configuration.
Drill through these two small
holes for Diagram 1 configuration.
Meet Parts (X and Y). These components
have been engineered to be lighter,
stronger, faster... well ok. Not technically
faster. But definitely makes for a sturdier
L-Desk that' s easier to assemble and
friendlier to the environment.
www.sauder.com/service
CAUTION
Make sure you have
packing foam or
throw away material
underneath the tops
near the drill area.
X
These eight holes
must be here.
Y
428728
Drill through these two small
holes for Diagram 1 configuration.
Drill through these two small
holes for Diagram 2 configuration.
Page 23
Publicité
