Beurer MG 230 Mode D'emploi page 12

7. Operation
The massage must be pleasant and relaxing at all times. Stop the massage or change your position or the
contact pressure if you find it is painful or unpleasant.
• Do not force any part of your body, in particular your fingers, between the rotating massage heads and
their mountings in the device.
• Lie down comfortably on the massager. Take care to ensure you are positioned in the middle of the mat
and that the massage heads to the left and right of your spine still have enough room to move.
• Switch on the massager with the
The device starts automatically with the Shiatsu massage on the full back setting. The LED shows the
current massage region.
You can select other settings as described below:
1. Shiatsu massage
Press the SHIATSU button. Select the desired massage region with FULL BACK (button 2), UPPER BACK
(button 3) and LOWER BACK (button 4).
Spot massage, i.e. Shiatsu massage without vertical movement, can be selected by pressing one of the
two SPOT buttons (number 6). The position of the localised massage can be changed by pressing and
holding one of the two SPOT buttons until the desired position is reached.
2. Rolling massage
Press the ROLLING button. Select the desired massage region with FULL BACK (button 2), UPPER BACK
(button 3) and LOWER BACK (button 4).
When the massage type (Shiatsu or rolling massage) is changed, the preselected region (full, upper, lower
back) is retained. Note that the massage region must be selected again when switching from localised
Shiatsu massage to rolling massage.
Heating function
Press the HEAT button (button 5) to switch on the heating function of the massage heads. The blue lights
in the massage heads change colour to red.
• Use the massager for max. 15 minutes and then leave it to cool down. Long massages can lead to over-
stimulation of the muscles, creating tension instead of aiding relaxation.
You can end the massage at any time by pressing the button
must first return to their start position when the device is switched off. This is indicated by a flashing LED
light. Once the position is reached, the device switches off.
• If the device is stopped be pressing a massage area button twice, it also returns to the starting position
after 15 minutes and then switches off.
• Do not disconnect the device from the mains supply during operation. Always switch it off first and wait
until it has returned to the initial position.
• Disconnect the power supply unit plug from the mains after using the device.
Note
• The device has an automatic shut-off mechanism set to a maximum operating period of 15 minutes.
8. Care and storage
CLEANING
WARNING
• Before cleaning disconnect the power supply unit from the mains socket and disconnect it from
the device.
• Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the
device or accessories.
• Smaller stains can be removed using a cloth or moist sponge together with a little liquid detergent
for delicate fabrics if necessary. Do not use any cleaning agents containing solvents.
button.
12
. Please note that the massage heads