Publicité
Les langues disponibles
Les langues disponibles
OPErATION
WArNING:
important safety warning and instructions before using this tool.
WArNING:
removal of the battery pack.
INSTALLING OR REMOVING THE BATTERY
PACK (FIG 2)
• To install the battery pack, slide the battery pack (1) into the
bottom of the tool housing (2) all the way until it locks in place
with a click, as shown in fIG 2. Lightly pull on the battery to
ensure it is locked into place and will not accidentally fall out of
the tool, causing an injury.
• To remove the battery pack, pull the battery pack away from the
tool while depressing the battery locking tab (3).
CHARGING THE BATTERY (FIG 3)
NOTE:
Always Check that the power supply corresponds to the
voltage on the ratings plate.
• Connect the charger adaptor (1) and the charger stand (3).
• Plug the charger adaptor (1) into a 120 Volt AC power source. The
green light on the charger stand (3) will illuminate, indicating the
charger is powered.
• Slide the battery (2) all the way into the charger stand (3) until
it locks in place with a click, as shown in fIG 3. The red light on
the charger stand will illuminate, indicating that the battery is
charging.
• The red light will go off after charging is complete.
• Batteries may become warm while charging. This is normal.
• If battery is hot after continuous use in the tool, allow it to cool
down to room temperature before charging. This will extend the
life of your batteries.
NOTE:
It takes approximately 3-5 hours to charge up a completely discharged battery.
WArNING:
in the locked or off position before any assembly, adjustments or changing accessories.
TRIGGER SWITCH ACTION
• Turn the drill on by depressing the trigger switch (4-fIG 1).
• Depressing the switch further will produce more speed and torque.
• use the reversing switch (5-fIG 1) to change the direction of rotation of the drill.
• The reversing switch has three positions: forward, Reverse, and Off (middle).
• Always check the rotation before beginning your work.
TWO-SPEED GEAR SWITCH (FIG 4)
• Slide the speed gear switch (A) to choose between position 1 for
high speed range (0-1,300 RPM) and position 2 for low speed
range (0-350 RPM).
• The low speed range has more power and torque. use the low
speed range for high power and torque applications.
• The high speed range is for fast drilling or driving applications.
LED WORK LIGHT
Your tool has a built-in LeD work light (6-fIG 1) to illuminate
the work area. When you turn on the tool, the work light will
automatically turn on.
To reduce the risk of serious personal injuries, read and follow all
Always be sure that the tool is switched off before insertion or
Always disconnect the battery pack from the tool or place the switch
2
3
1
2
3
FIG 3
FIG 4
A
2
FIG 2
3
1
2
1
9
Publicité
