Glacier bay 873W-2004 Guide D'utilisation Et D'entretien page 7

Installation (continued)
5
Installing the plaster guard
□
Place the plaster guard (L) onto the body (D)
and secure with the screws (K).
K
L
D
6
Installing the shower arm
□
Insert the long end of the shower arm (B)
through the ange (A), and wrap thread
sealant tape around the long end of the shower
arm (B) in a clockwise direction, as shown.
□
Install the long end of the shower arm (B)
into the pipe elbow inside the wall. Carefully
tighten the shower arm (B) with a clean strap
wrench. Do not over tighten.
□
Wrap thread sealant tape around the pipe
threads of the tub spout outlet (1, not included)
in a clockwise direction, as shown.
□
Connect the tub spout outlet pipe (the tub
spout outlet pipe should project 4 in. to 4-1/4 in.
from the nished wall) to the lower pipe elbow
(2, not included). Tighten the elbow and tub
spout outlet pipe connections with a strap
wrench.
B
7
Please contact 1-855-HD-GLACIER for further assistance.
A
2
1
4 in. to 4-1/4 in.
Wall
HOMEDEPOT.COM