Publicité
Les langues disponibles
Les langues disponibles
Installation (continued)
ATTACHING THE DUCT (FOR OUTDOOR VENTED
INSTALLATIONS)
WARNING: FUEL (GAS) BURNING RANGES MUST BE VENTED
OUTDOORS USING, AT MINIMUM, METAL DUCTWORK AND RANGE
HOODS OF SUFFICIENT CAPACITY .
NOTE:
In interior vented installations, air is recirculated through a charcoal
filters and exhausted through the top of the chimney. Skip this step if
you are recirculating the air indoors.
- Attach the supplied duct (G) to the range hood (A) and
connect it to your exterior duct using duct tape.
INSTALLING THE CHIMNEY
WARNING:
Sharp edges . Wear safety gloves .
-
Plug the range hood into the grounded electrical outlet and make
sure it is operating correctly before proceeding .
-
Place the upper chimney (C) inside the lower chimney (B) and
place them both onto the range hood . Hang the lower chimney
(B) on the lower support bracket (F) as shown in figure 10.
-
Slide the upper chimney (C) upwards and hang it on the upper
chimney support bracket (E) as shown in figure 11.
-
Secure the chimney extensions to the support brackets with
tapping screws (BB) from both sides as shown in figure 11.
A
C
B
C
B
11
Please contact cs@conglomkb.com or 1-877-333-0098 for further assistance .
G
Fig. 9
E
Fig. 10
E
Fig. 11
CONGLOMKB .COM
F
E
E
BB
Publicité
