Publicité
Les langues disponibles
Les langues disponibles
SET UP & USE
INSTALLATION GUIDE
LOCATION
1. Examine the dryer after unpacking. Check for damage such as a misaligned
door, broken door or dent in the cavity. If any damage is visible, DO NOT install,
and call customer service.
2. Check to ensure that you have four (4) leveling legs.
3. Install the dryer on a flat, level surface. If the surface is uneven, adjust the
leveling legs.
4. Install the dryer away from direct sunlight; direct sunlight may affect the
acrylic coating, plastic and electrical components. The room temperature
should not fall below 32°F.
5. Check the ventilation. DO NOT block the air vents, especially when the dryer is
installed on a carpeted floor. If the air vents are blocked during operation, the
dryer may overheat and eventually fail. For proper ventilation, allow at least
5 inches of space between the dryer top, sides, rear, and adjacent surfaces.
Ensure adequate space for ventilation. It is recommended that the unit be
vented outdoors. (Ventilation Kit not included.) A ventilation kit with a 4"
diameter duct can be purchased at your local hardware store.
6. Install the dryer away from heating appliances and water taps. Keep the
dryer away from heat, steam, or splashing liquids. Never splash water onto
the control panel. These things can adversely affect the wiring and electrical
conduction contacts of the dryer.
ADJUSTING THE LEVELING LEGS
The dryer is shipped with a bag containing the user guide and
four leveling legs. See the illustration to the right to install and
adjust the leveling legs.
If the dryer is placed on an uneven or weak surface, noise or
vibrations will occur from the appliance. If the floor is uneven,
adjust the height level of the leveling legs accordingly. DO NOT
insert pieces of wood or any other objects under the legs.
Page 10
Leveling Leg
Bottom View
Publicité
