Bestron ACM1100G Mode D'emploi page 20

operAtIon - Before first use
Clean the appliance a couple of times by filling it with water only and following the instructions below. Dispose
of the water after use.
operAtIon - Making coffee
Filling with water
1. Place the appliance on a flat and steddy surface.
2. Remove the water tank from the appliance and fill it with sufficient water to set 2, 4 or 6 cups of coffee
according to the water level indicator. Then place the reservoir back in the appliance.
• Never fill the water tank with hot water, milk, tea or other liquids than cold tap water.
Making coffee using coffee beans
1. Pull the filter housing (6) outwards and place the filter holder (4), then the permanent filter (3) or paper
filter (101), and finally the filter cover (2). Then close the filter holder.
2. Open the bean container lid (1) and fill the bean container (9) with up to 90 grams of roasted coffee
beans. Then place the lid back on the reservoir.
3. Adjust the grind fineness of the coffee beans with the rotary knob (8) on top of the bean container.
4. Insert the plug into the socket. Indicator lights
5. Set the desired number of cups of coffee by pressing the
cups is equal to the amount of water in the water tank. During the brewing process, the appliance will
use all the water in the water tank.
6. Adjust the coffee strength with the
press the button for less strong coffee. The indicator light goes out.
7. Place the glass coffee jar (7) on the hotplate.
8. Press the " / " button on the control panel. After approx. 3 seconds, the appliance starts to grind the
on off
coffee beans. Then the brewing process starts after approx. 3 seconds. The coffee will now be prepared.
9. The drip-stop enables you to pour a cup of coffee before the coffee maker has finished. Quickly place
the coffee jar back on the hotplate to prevent the filter from overflowing.
10. An acoustic signal sounds at the end of the brewing process. The hotplate keeps the coffee warm for
approx. 35 minutes before switching off automatically.
11. Remove the plug from the socket after use.
• Never use unroasted or humid coffee beans. These can severely damage the device.
Making coffee using filter coffee
1. Pull the filter housing outwards and place the filter holder, then the permanent filter or paper filter (101).
Fill the filter with the desired quantity of filter coffee (1 measuring spoon per cup). Make sure the number
of cups is equal to the amount of water in the water tank. During the brewing process, the appliance will
use all the water in the water reservoir. Place the filter cover. Then close the filter holder.
2. Insert the plug into the socket. Indicator lights
3. Press the button to deactivate the coffee grinding function. The indicator light lights up.
• Note that the
with ready-to-use ground filter coffee: the strength is then determined by the amount of filter coffee
and the amount of water used.
4. Place the glass coffee jar on the hotplate.
5. Press the " / " button on the control panel. After approx. 3 seconds, the brewing process starts. The
on off
coffee will now be prepared.
6. The drip-stop enables you to pour a cup of coffee before the coffee maker has finished. Quickly place
the coffee jar back on the hotplate to prevent the filter from overflowing.
7. An acoustic signal sounds at the end of the brewing process. The hotplate keeps the coffee warm for
approx. 35 minutes before switching off automatically.
8. Remove the plug from the socket after use.
button. This setting is set to "strong coffee" by default. If required,
indicator light goes out. Coffee strength can not be adjusted when making coffee
20
user's instructions
and on the control panel (10) light up.
, or button. Make sure the number of
and on the control panel light up.