Publicité
Les langues disponibles
Les langues disponibles
Assembly
WARNING:
When assembling or inserting the extraction filter
as well as the carbon filter, the appliance must not
be connected to the mains.
Failure to use the mounting fixtures may lead to a
risk of electric shock.
CAUTION:
Before mounting, check that the wall has enough
load capacity to bear the cooker hood.
When drilling the holes in the wall always make
sure that no existing electrical cables or other ob-
jects are damaged.
Make sure that the ventilation slots are clear of
obstacles and are not covered.
NOTE: Recommendations for preparation work
When installing, ask another person to assist.
Wear protective gloves to prevent injuries from
any sharp edges.
Drilling dimensions
Fig. 1
unit mm
Fig. 2
Fig. 3
Fig. 5
Determine the position of the cooker hood central-
ly above the cooking area in accordance with the
specified safety distances.
Totally 6x mounting holes with a diameter of approx.
8 mm are necessary for the wall mounting. Insert the
supplied dowels [Fig. 1].
First, drill the holes for attaching the housing ac-
cording to the enclosed drilling template. Check
the markings with a spirit level!
Turn in the upper screws 2x ST4*30mm for the
-
suspension of the housing so far that they pro-
ject approx. 5 mm out of the wall.
Fix the bracket for the upper shaft closure with the
screws 2x ST4*40mm; after determining the ex-
tension length of the shaft cover.
For exhaust mode:
(included in delivery) with an inner diameter of
150 mm onto the connecting piece (extraction duct).
Secure the hose with the cable tie [Fig. 2].
Hang up the housing. Check the secure hold and
the horizontal position [Fig. 3].
For exhaust mode:
exhaust hose and connect it with the outlet opening.
40
Fig. 4
Attach a flexible exhaust hose
Check the correct position of the
Publicité
