Publicité
Les langues disponibles
Les langues disponibles
The wine refrigerator seems
to make to much noise
The door will not close
properly.
LED could not display.
LED display error - Lo
Buttons are not functional.
Compressor will not start
Compressor re-start
Dew on the surface of
cabinet：
Liquid sound
Condensation formed inside
the cabinet
Error code E2
Attention
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.
The wine refrigerator is not level.
Check the fan.
The wine refrigerator is not level.
The door is reversed and not properly installed.
The seal is weak. The shelves are out of position.
Main control board does not work.
PCB Problem. There is some problem with the plug.
Weak quality of display.
Temperature point is out off. Check the service center.
Temperature controller panel is damaged.
Room temperature is lower than desired temperature.
Compressor will stop working when cooling system in the
cabinet reaches
presetting temperature, and re-start
working until the desired temperature is achieved. Allow a
minimum 5 minute interval before re-starting.
The surface of wine cabinet especially the glass door
appear some frost if item in a damp room. This is due to
the moisture in the air coming into contact with the
cabinet. Please wipe it away with dry cloth.
（1）、The sound of compressor when starts or stops
working
flowing
（2）、The
refrigeration system
（3）、The evaporating sound of refrigerant in the
evaporator
Under the environment with high level of humidity or the
door of wine cabinet has been left open for a long period
or opened frequently, wipe off the door and walls and
leave the door closed as long as possible.
Desired temperature is not reached.
If necessary defrost the device (Please follow the hints for
manual defrosting in chapter cleaning).
sound
of
refrigerant
in
the
37
Publicité
