Valor LT1 Serie Guide D'installation

INSTALLATION INSTRUCTIONS
Adjustable Finishing 1" Trim 2575LFB
Use with Valor LT1 2500 Heater Models ONLY (series K or later)
DANGER
!
A barrier designed to reduce the risk of burns from the hot
viewing glass is provided with this appliance and must be
installed for the protection of children and other at-risk
individuals.
The 2575LFB Linear 1-inch finishing trim is designed
to be used on Linear LT1 2500 Valor heaters.
The application of this kit does not affect the venting
capabilities or method of preparation of the 2500 heater
as described in the installation manual.
41-1/2" [1054 mm]
Trim size
4009377-03
©2023, Miles Industries Ltd.
LT1 Series
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
INSTALLER: Leave this
manual with the appliance.
CONSUMER: Retain this
manual for future reference.
Note: This kit must be
installed or serviced by a
qualified installer, service
agency or gas supplier. These
instructions are to be used
in conjunction with the main
installation instructions
for the above listed heater
model.
This trim fits flat against the front of the cement board
with the ability to tuck additional non-combustible
materials up to 1/2" thickness behind the trim.
DO NOT COVER the trim with any finish! See appliance
installation manual for more information about
finishing around this kit.
Overview (2500 engine and 2575LFB sold separately)
2500 Fireplace
Side doors
Cover plate
Trim
Barrier screen
1