Mounting The Handlebar; Adjusting Of The Folding Device - Urbanglide Ride 85+ Notice Originale

Assembly
Handle L
Handle L
Screw adjustment

Mounting the handlebar

To assemble the handlebars of your scooter, follow these steps :
1. Insert the two handles into the handle of your scooter.
2.Screw the two handles.
To disassemble the handlebars of your scooter, follow these steps:
1. Unscrew the two handles of the handle of your scooter.
2. Remove both handles.

Adjusting of the folding device

Locking pin
Handle R
Handle R
1.When the space in the folding device is too large, the
upper screw can be turned to the right with an Allen
key and the left and right screws must be adjusted.
2.Before adjustment, make sure that the scooter is in
the adjustment lock state and after adjustment, that
the folding switch is elastic and can be used normally.
The locking pin may normally fall down.