Sony IPELA SNC-DF70N Manuel D'installation page 49

Insert the cables through the side
3
conduit hole, and connect the cables
to their respective connectors, and
secure them with the cable clamp.
Network cable: Connect to a
network port of this unit.
24 V AC/12 V DC (power input)
cable: Connect to an AC/DC IN
connector.
I/O cable: Connect to EXT CTRL
connector.
Audio cable: Connect to MIC/SP
connector.
Attach the plug that was removed
4
from the side conduit hole to the
bottom conduit hole.
Notes
• When you connect a pipe/plug to the
conduit hole, be sure to turn the pipe/
plug all the way and lock it in place.
Otherwise, moisture may leak into the
casing.
• When you insert the plug in the bottom
conduit hole, clean the thread grooves
of the bottom conduit hole and install
the plug securely.
• Cover the joint part of the pipe/plug
with silicon sealant, etc. to prevent
moisture from getting inside the
casing.
• Use a pipe/plug with a thread length of
12 mm or less so that it does not
damage the camera.
4
When installing on a ceiling or wall,
fix the supplied wire rope to the
bottom of the camera and the ceiling
(or wall).
Fix the wire rope to the ceiling or
1
wall.
Remove the screw on the bottom of
2
the camera, and string the screw
through the hole of the wire rope.
12 mm or less
Then secure the screw firmly so that
it will not come loose.
Ceiling
5
Install the camera on the ceiling or
wall with the four supplied screws.
Notes
• Be sure to install the supplied wire rope to
the camera and the ceiling or wall.
• If the ceiling or wall material is not strong
enough to hold the screws, the camera may
fall off. Reinforce the ceiling or wall as
needed.
• If you cannot use screws on a ceiling or
wall, or if you want to hide the camera to
be less conspicuous, use the YT-ICB70 in-
ceiling bracket (optional) with which you
can mount the camera on the ceiling.
Installing the Unit
Wire rope
15
GB