LG CBGS3628S Manuel D'installation page 12

us_main.book.book Page 12 Thursday, May 12, 2022 9:01 AM
12 INSTALLATION
Yellow tips on outer cones —
b
Normal for LP gas
Soft blue flames — Normal for
c
natural gas
If burner flames look like
is normal for burner flames, depending on the
c
type of gas you use.
With LP gas, some yellow tipping on outer cones is
normal.
7. Adjusting the Surface Burner Low
Flame (Simmer) Setting
1
Light all surface burners.
2
Turn the knob on the burner being adjusted
to LO (LOW).
3
Remove the knob.
4
On center and right front knob rings only,
remove the plastic cover
by turning it counterclockwise.
5
For single-valve burners (left front, left rear,
right rear), insert a small, flat-blade
screwdriver into the valve stem.
For dual-valve burners (center, right front),
insert a small, flat-blade screwdriver into the
hole to the left of the valve stem.
Single Valve Adjustment Screw
a
Dual Valve Adjustment Screw
b
6
Turn the adjustment screw until the flame
reaches the desired size.
7
Replace the knob.
, call for service. or
a b
on the knob ring
a
8
Test the flame stability.
Test 1
• Turn the knob from HI to LOW quickly.
• lf the flame goes out, increase the flame
size and test again.
Test 2
• With the burner on a LOW setting, open and
close the oven or cabinet door quickly.
• If the flame is extinguished by the air
currents created by the door movement,
increase the flame height and test again.
9
Repeat steps 1 - 6 for each surface burner.
10
After setting the low flame, turn off the
burner.