Model Description; All Models; Model Designation; Specifications - Hatco Glo-Ray GRFHS Série Manuel D'installation

MODEL DESCRIPTION

All Models

Glo-Ray Fry Holding Stations ensure fried foods will remain
®
at optimum temperatures without cooking or drying them
out. Standard models are constructed of aluminum and
stainless steel featuring a POWER I/O (on/off) switch, a preset
thermostatically-controlled heated base, ceramic upper heating
element(s), stainless steel trivet with sectional divider, and a
6' (1829 mm) cord and plug set.
Various options and accessories can be supplied to customize
the Fry Holding Station. Refer to the OPTIONS AND
ACCESSORIES section near the back of this manual for
details.

MODEL DESIGNATION

Fry Holding Station

SPECIFICATIONS

Plug Configurations

Units are supplied from the factory with an electrical cord and
plug. Plugs are supplied according to the application.
WARNING
ELECTRIC SHOCK HAZARD: Plug unit into a properly
grounded electrical receptacle of the correct voltage,
size, and plug configuration. If plug and receptacle do not
match, contact a qualified electrician to determine and
install proper voltage and size electrical receptacle.
NOTE: Specification label located on the lower, left-hand side
of the unit. See label for serial number and verification
of unit electrical information.
G R F H S - P T x x S
Glo-Ray
Trivet
POWER I/O (on/off)
Switch
Fry Holding Station (GRFHS-21 shown)
Short
Width (inches)
No Characters = Bin
PT = Pass-Through
PTT = Pass-Through Tunnel
NEMA 5-15P
Plug Configurations
NOTE: Receptacle not supplied by Hatco.
4
English
Divider
NEMA 5-20P
Form No. GRFHSM-1020