INVENTOR MP864W Manuel D'utilisateur page 13

2.
Remove the plastic cover located on
the top right or left (depending on initial
door installation side) of the door hinge,
and unscrew the two screws with the
stabilizing pin.
EN
1.
Adjust the leveling foot to its highest
position. Tilt the unit slightly backwards to take
the door off. Rest the unit on something solid
so that it will not slip during the door reversing
process.
Do not lay the unit flat as this may
damage the coolant system.
3.
Slightly tilt so that you may have
access to the front bottom bracket.
Unscrew the two screws located on
the bottom left or right (depending
on initial door installation side)and
remove the foot from the opposite
side. Once top and bottom screws and
also the opposite foot are removed,
the door will be completely released.
13