Samsung HW-C450 Mode D'emploi page 5

LY 06 TROUBLESHOOTING
Before seeking assistance, check the following.
ia
Soundbar does not turn on.
• Check whether the power cord of the Soundbar is correctly inserted
into the outlet.
Subwoofer does not connect automatically.
• Follow the steps below to connect the subwoofer manually.
1. Rear of Subwoofer
연결
2. Remote
Control
사운드
모드
3. Soundbar
음량 우퍼레벨
ce
SOUNDBAR
4. Connection
complete
T" Soundbar works erratically.
• After removing the power cord, insert it again.
• Power the external device off/on and try again.
• If there is no signal, the Soundbar automatically turns off after a
certain period of time. Turn on the power.
If the remote control does not work.
• Point the remote directly at the Soundbar.
• Replace the batteries with new ones.
e
Soundbar does not output any sound.
• The volume of the Soundbar is too low or muted. Adjust the volume.
• When any external device (STB, Bluetooth device, mobile device, etc.)
is connected, adjust the volume of the external device.
• For sound output of the TV, select Soundbar. (Samsung TV: Home
( ) → Menu → Settings (
Sound Output → Select Soundbar)
• Remove the cable from the Soundbar and then reconnect it.
Subwoofer does not output any sound.
• Check whether the LED on the rear of the Subwoofer lights in blue.
Reconnect it when the blue LED blinks or the red LED lights.
; ;
5 Sec
Red and Blue is On
연결
First, press the button on the
remote control to turn on the
display, and then press the Up
button on the remote control
5 Sec
for at least 5 seconds.
사운드
모드
음량 우퍼레벨
ID SET
SOUNDBAR
The LINK LED indicator stops blinking and
glows a solid blue (connection complete).
) → All Settings (
Soundbar does not connect via Bluetooth.
• When connecting a new device, switch to "BT PAIRING" for
connection. (Press the
press the
at least 5 seconds.)
• Reconnect it after removing the Bluetooth speaker list on
the device to connect. (Samsung TV: Home (
Settings (
Bluetooth Speaker List)
Soundbar does not appear on the Bluetooth device list of the TV.
• Disconnect the power cord of the Soundbar completely and
reconnect, and then try searching again.
• Connect the TV and Soundbar with an optical cable, and select
;
the "D.IN" mode by pressing the
top of the Soundbar. See if the audio output works normally,
Blinking
and try searching again.
blue fast
Sound drops out when connected via Bluetooth.
• Some devices can cause radio interference if they are located too
close to the Soundbar. e. g. microwaves, wireless routers, etc.
• If your device that is connected via Bluetooth moves too far away
from the Soundbar, it may cause the sound to drop out. Move the
device closer to the Soundbar.
• If a part of your body is in contact with the Bluetooth transceiver
or the product is installed on metal furniture, sound may drop out.
Check the installation environment and conditions for use.
Soundbar does not turn on automatically with the TV.
• When you turn off the Soundbar while watching TV, power
synchronization with the TV is disabled. First turn off the TV.
) → Sound →
PAIR button on the remote control or
(Source) button on the top of the soundbar for
) → All Settings ( ) → Sound → Sound Output →
(Source) button on the
) → Menu →
English - 5