Scotts S200 Manuel D'utilisation page 5

WALL-MOUNTED CHARGING STATION
See Figure 3, page 7.
The charger can be mounted on the wall, which allows you to
recharge the battery pack while it is still installed in the tool.
 Charger should be mounted on a wall stud using the
screws provided.
 Position the charger close enough to an outlet so an
extension cord is not required. Wrap any excess cord
remaining after plugging in the charger around the charger
body.
 Make sure to mount the charger high enough to prevent
unauthorized activation of the tool during charging.
 With the battery installed and the tool turned off, place
the tool in the charger by aligning the raised ribs on the
tool housing with the grooves in the charger as shown.
 Slide the tool down until it is fully seated on the charger.
LED FUNCTION OF CHARGER
MODE BATTERY PACK
Without
Power
battery pack
Hot battery pack
Testing
Cold battery pack
Deeply discharged
Defective
Defective
• If defective, try to repeat the conditions a second time by removing and reinstalling the battery pack. If the LED status repeats a
second time, try charging a different battery.
• If a different battery charges normally, dispose of the defective pack (see Maintenance section).
• If a different battery also indicates "Defective," the charger may be defective.
Charging
Charging
Charged
Battery is charged
Energy
Battery full /
Save Mode
Energy Save mode
OPERATION
CHARGING A HOT BATTERY PACK
When using a tool continuously, the battery pack may
become hot. A hot battery pack may be placed directly
onto the charger port but charging will not begin until the
battery temperature cools to within acceptable temperature
range. When a hot battery pack is placed on the charger,
the red LED will begin flashing and the green LED will be off.
When the battery pack cools, the charger will automatically
begin charging.
CHARGING A COLD BATTERY PACK
A cold battery pack may be placed directly onto the charger
port but charging will not begin until the battery temperature
warms to within acceptable temperature range. When a cold
battery pack is placed on the charger, the red LED will begin
flashing and the green LED will be off. When the battery
pack warms, the charger will automatically begin charging.
RED GREEN
LED LED
OFF Ready to charge battery pack.
ON
When battery pack reaches cooled temperature, charger
begins charge mode.
When battery pack reaches warmed temperature, char-
OFF
ger begins charge mode.
Flashing
Charger pre-charges battery until normal voltage is
reached, then begins charge mode.
OFF Battery pack or charger is defective.
Fading
Battery is being charged.
ON
Flashing
OFF Battery is charged; charger is in Maintenance Mode.
ON
OFF Battery is charged and charger is in Energy Save mode.
Fading
5 — English
ACTION