Télécharger Imprimer la page

Scotts S200 Manuel D'utilisation page 4

Publicité

Les langues disponibles

Les langues disponibles

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
 If any parts are damaged or missing, please call 1-877-243-2774 for assistance.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
APPLICATIONS
You may use this product for the following purpose:
 Charging Scotts
20 V Li-Ion battery packs
®
NOTICE:
If at any point during the charging process none of the
LEDs are lit, remove the battery pack from the charger
to avoid damaging the product. DO NOT insert another
battery. Return the charger and battery to your nearest
authorized service center for service or replacement.
NOTICE:
Charge in a well-ventilated area. Do not block charger
vents. Keep them clear to allow proper ventilation.
ENERGY SAVE MODE
The charger will enter Energy Save Mode when not charging
or when maintaining batteries. This allows the charger to
conserve energy by charging batteries only as needed, and
also protects the cells and maximizes the life of your batteries.
ASSEMBLY
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
OPERATION
CHARGING
See Figures 1 - 2, page 7.
Battery packs are shipped in a low charge condition to
prevent possible problems. Therefore, you should charge
them before first use. If the charger does not charge your
battery pack under normal circumstances, return both the
battery pack and charger to your nearest repair center for
electrical check.
Battery pack will be charged in approximately 45 minutes.
 Make sure the power supply is normal household voltage,
120 volts, AC only, 60 Hz.
 Connect the charger to a power supply.
 Attach the battery pack to the charger by aligning the
raised ribs on the battery pack with the grooves in the
charger, then slide the battery pack onto the charger.
 Ensure contacts on the battery pack engage properly
with contacts in the charger.
 Do not place the charger in an area of extreme heat or
cold. It will work best at normal room temperature.
 The battery pack may become slightly warm to the touch
while charging. This is normal and does not indicate a
problem.
 When the battery pack is charged, the green LED will
remain on, indicating the charger is in Maintenance Mode.
 After completing Maintenance Mode, the green LED
will begin fading on/off continuously. This indicates the
battery is charged and the charger is in Energy Save
Mode.
 Charger will periodically wake from Energy Save Mode to
ensure the battery pack remains in a fully charged state.
 To remove the battery pack from the charger, pull up on
the battery pack.
4 — English

Publicité

loading